Xtensa

From Lazarus wiki
Jump to navigationJump to search
Warning-icon.png

Warning: The ESP32 support is highly experimental and prone to be broken. This description is work in progress.

Building FPC

Preparations


So far Linux and Mac only


Native stable FPC must be installed and working on the system.

Install esp-idf based on the instructions given here:

Get Started (for Stable Release)

Follow the instructions to a least step 8 where you build the hello_word demo project.

copy all the freshly compiled .a files from the current project directory to a directory of your choice:

 mkdir ~/esp/xtensa-esp32-elf-libs
 find . -name "*.a" -exec cp {} ~/esp/xtensa-esp32-elf-libs \; 

Now you are ready to compile fpc and rtl.

execute

export IDF_PATH=~/esp/esp-idf
source ~/esp/esp-idf/export.sh

to get the path and environment set (namely tools path and $IDF_PATH are needed)

Change into the fpc directory and run

 make FPC=fpc CPU_TARGET=xtensa OS_TARGET=freertos "CROSSOPT=-Cplx6 -XPxtensa-esp32-elf- -Cfhard" all -j


If this does not work, try:


 cd compiler
 lazbuild ppcxtensa.lpi

to get pp .

now compile the rtl:

 cd ../rtl/freertos
 make FPC=../../compiler/xtensa/pp  OS_TARGET=freertos "OPT=-Cplx6 -Cawindowed -XPxtensa-esp32-elf- -Cfhard" clean all


Create a hello world program in the fpc dir and compile it with

 compiler/xtensa/pp -Furtl/units/xtensa-freertos/ -Tfreertos -Cawindowed -XPxtensa-esp32-elf- -O3 -Wpesp32 -Fl~/esp/xtensa-esp32-elf-libs  -Fl~/.espressif/tools/xtensa-esp32-elf/esp-2019r2-8.2.0/xtensa-esp32-elf/xtensa-esp32-elf/lib/ hello

Get partition-table.bin and bootloader.bin from the hello_world example compiled above and copy them into the same dir as the compiled hello.bin

Flash with

 esptool.py -p /dev/ttyUSB0 -b 460800 --before default_reset --after hard_reset --chip esp32  write_flash --flash_mode dio --flash_size detect --flash_freq 40m 0x1000 bootloader.bin 0x8000 partition-table.bin 0x10000 hello.bin

Monitor the output with:

 idf_monitor.py  --port /dev/ttyUSB0 hello.elf