FPReport FAQ
│
English (en) │
General
Read the README.txt file
Before you compile the FPReport, have a look at the README.txt
FPReport <> LazReport
FPReport is not LazReport!! These are two different reporting systems.
- LazReport is based on FreeReport 2.32, see LazReport_Documentation.
- FPReport is written from scratch, see FPReport documentation.
Papermanager must registered
You never registered the standard page sizes with:
if PaperManager.PaperCount=0 then
PaperManager.RegisterStandardSi
Fontmanager
Your report used LiberationSans font. Make sure you added the search paths to the font cache. eg:
{$IFDEF UNIX}
gTTFontCache.SearchPath.Add(GetUserDir + '.fonts/');
gTTFontCache.SearchPath.Add('/data/devel/Wisa/fonts/Liberation/');
gTTFontCache.BuildFontCache;
{$ENDIF}
In windows this useable
gTTFontCache.ReadStandardFonts;
gTTFontCache.BuildFontCache;
FPC FPReport
I did not find FPReport in my FPC dir
It is located in the FPC\packages\fcl-report dir, but only in FPC trunk (=3.1.1) since rev. 36962 (20.Aug. 2017)
What is the minimum requirement
Info from Mailinglist - FPC 2.6.4 (and Lazarus 1.6.2), but you will need to copy some additional units from the trunk version of the FPC source repo (in particular, fpexprpars, and fcl-pdf) and the Lazarus trunk repro too
Lazarus FPReport
I did not find FPReport in my Lazarus dir
Only in Lazarus trunk since rev. 55719 (20.Aug. 2017). Look in LAZARUSDIR\components\fpreport there is a runtimepackage lclfpreport.lpk.
I cannot compile the FPReport packages
As of 20th January 2019 FPReport in the 64 bit version is broken (Windows version at least). The 32 bit version should compile flawlessly (see also "I did not find FPReport in my Lazarus dir").
My Report does not run/start in Windows
Start the applikation from the console, so you can see if some dll's are missing. Normally freetype-6.dll and zlib1.dll are missing. For more information look into the README.txt.
My Font is not found in windows
You have to use the PostScriptName of the font. Eg. under windows you have the font 'Arial' - this is one of the standard font - but you have to write Memo.Font.Name := 'ArialMT' because ArialMT is the correct PostScriptname.
for i:= 0 to gTTFontCache.Count-1 do begin
try
Memo1.Append(TFPFontCacheItem(gTTFontCache.Items[i]).HumanFriendlyName +'...'+ TFPFontCacheItem(gTTFontCache.Items[i]).PostScriptName);
except
Memo1.Append('ERROR in...'+ TFPFontCacheItem(gTTFontCache.Items[i]).FileName)
end;
end;