Function code size

Advice from programmer Rika.

Pascal function binary size can be measured (to within the procedure entry alignment... usually 16 bytes) with:

procedure MyProc;
begin
  // ...
end;

// Must immediately follow MyProc in the source!
// Uses the implementation detail that the linker will lay them out in the same order (which is not guaranteed by any linker, so this may not work).
procedure MyProcEnd; 
begin
end;

begin
  writeln('MyProc code size: ', pointer(@MyProcEnd) - pointer(@MyProc), ' b');
end.

For assembler routines, either do the same but make MyProcEnd assembler too (still not sure if it works, I use the method below... but it definitely doesn’t work when mixing Pascal and assembler procedures). Or do the following (finer and more future-compatible way that sadly does not compile with Pascal routines):

label MyAsmProcEnd;

procedure MyAsmProc; assembler;
asm
  // ...
MyAsmProcEnd:
end;

begin
  writeln('MyAsmProc code size: ', pointer(@MyAsmProcEnd) - pointer(@MyAsmProc), ' b');
end.

This method misses the epilogue size, but the epilogue is negligible (1-digit) and constant; and if you have X bytes, after adding 17 more bytes of instructions you will have exactly X + 17.